Did you know how to lubricate handpieces properly?

See the difference between a properly lubricated turbine vs a turbine with a lack of lubrication

---

Lubricate Every Use

For both high and low-speed handpieces lubrication;

For drop oil, with the bur inserted (for the high-speed), place lubricant (2-3 drops) into the air intake, run and purge unit for 20 seconds, or until all excess oil is expelled.

For aerosol oil, with the bur inserted (for the high-speed), spray lubricant for 1 second into the air intake and run on purge unit for 20 seconds, or until all excess oil is expelled.

If expelled oil is colored, repeat the lubrification process until expelled oil is clear.

---

Tips

• Remove the burs and other attachments (never sterilize with attachment).
• Lever-operated chucks must be closed.
• Never cool a hot handpiece under cold water or by placing it in a refrigerator.
• Allow drying cycle to complete before removing handpiece from the autoclave to ensure that all moisture has been removed.
• Make sure the handpiece is completely cool and dry before operating.
• Have autoclave unit serviced regularly by manufacturer’s representative.
• Do not cheat the bur this will damage the chuck.
• Do not use pliers to remove burs.
• Use a proper oil adaptor for your aerosol can.
• Set air pressure according to manufacture (usually between 30-40 psi).

---

Is your dental unit due for preventive maintenance?

Contact our team of dispatchers to schedule your maintenance!